Drip Tube / Poly Tube / Drip Laterals
Drip
Irrigation requires Polyethylene Lateral as the main water delivery
for the drippers and micro sprinklers, that is the line that is
used from the valve to the plants or from the main line to the
plants. There are many nominal sizes of drip tubing that are used
for drip irrigation. We provide polyethylene laterals in sizes
of 10mm ID and 13mm ID. The fittings for these two are not interchangeable;
make sure you use the correct fittings for the size of your tubing.
The 13mm or the 10mm serves as the main line or a branch line,
into which the, drippers, micro sprinklers or 6mmID connectors
are inserted. The poly tubing is made from high quality polyethylene,
with 2% Carbon black for extra resistance to the damaging effects
of ultraviolet rays. All of out tubing have been designed to meet
every demand of low volume irrigation from agriculture installation,
landscape installations to backyard gardens, and it can be installed
above or below the ground.
Introduction
to Micro Tube / Distribution Tube
The
6mmID and 4mm ID micro tube or sometime refer to as us a distribution
tube serves as an individual feeder line to deliver the water
to each dripper or micro sprinkler. The micro tubing is available
in one basic material poly which is hard, made from high quality
polyethylene compounds, with 2?+ Carbon Black for extra resistance
to the damaging effects of ultraviolet rays. All of out micro
tubing have been design to meet every demand of low volume irrigation
system installations.
Introduction
to Fogger
2
GPH Fogger with barbed end. This fogger is used to spray above
the plants and flowers inside or outside close structure. It does
not spray a harsh Spray, but a very nice and noble mist spray
on plants.
